Not that Ive ever noticed. I have some used ones with late 60's date codes
that are fine. I also picked up a distributed amp with 13 NOS 1983 date
codes recently. They were all fine after a 5 minute warm up when I then used
the original National test jig to match them. Got nice prices on Ebay.
The Eimac 8122W often has a much higher bias requirement than the RCA and is
out of range of the bias pot. Its a simple matter to move the range from the
stock -25 to -45V up to -35 to -55V. The Eimac has a bias range about half
that of the RCA so they still require matching.
Carl
KM1H
Carl
KM1H
----- Original Message -----
From: "Pat Barthelow" <aa6eg@hotmail.com>
To: <amps@contesting.com>
Sent: Tuesday, August 14, 2007 12:42 PM
Subject: Re: [Amps] Project for 8122 tubes
> folks:
> Are 8122 Tubes that have been in storage for possibly Decades without use,
> likely to have internal gas problems?
>
> Sincerely, Pat Barthelow aa6eg@hotmail.com
> http://www.jamesburgdish.org
> Jamesburg Earth Station Moon Bounce Team
> http://www.cq-vhf.com
>
>>From: "sulai je" <7z1sj@jeeran.com>
>>Reply-To: 7z1sj@jeeran.com
>>To: <amps@contesting.com>
>>Subject: [Amps] Project for 8122 tubes
>>Date: Tue, 14 Aug 2007 13:03:08 +0300
>>
>>
>>Hello
>>I had some RCA 8122 tubes in my junk box since long time. Thinking to use
>>them in a homebrew project so I start to search for an amplifier project!
>>Either to UHF or VHF . HF Googling the net yields a zero project for those
>>tubes.
>>
>>if any on can help with schematic and more info I will be appreciated in
>>advance .
>>73s de 7z1sj Sulaiman
>>_______________________________________________
>>Amps mailing list
>>Amps@contesting.com
>>http://lists.contesting.com/mailman/listinfo/amps
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|