Carl wrote:
> FILAMENT OPERATION - The rated filament voltage for the
> 3-500Z is 5.0 volts.
> Filament voltage, as measured at the socket, should be
> maintained within the
> range of 4.75 to 5.25 volts to obtain maximum tube life.
> Ive always believed that when in doubt follow the
> manufacturers
> recommendations. Unless you have a big budget that is.
Which agrees with what I wrote and what Carl even was kind
enough to repost:
>> The real truth is if the voltage on your 3-500Z is
>> between 5
>> or 5.25 volts, or even if it is a little high, it won't
>> make
>> a bit of difference in the life of the tube if you lower
>> it
>> to some magical number. You won't see 10,000 operating
>> hours
>> in amateur service, and you almost certainly won't have a
>> tube that fails because of low emission unless you run
>> the
>> thing at 6 volts. If you keep the voltage somewhere near
>> 5
>> volts it will be like 99% of all the other tubes that
>> fail
>> and dies from something you really can't control.
>>
>> The main reason you have taps on that transformer is to
>> set
>> the HV. The bandswitch and tuning cap, because of cost
>> necessity in the Ham market, don't have a lot of
>> headroom.
>> The most damaging thing is to let the HV get too high, so
>> the taps allow you to keep the HV at a reasonable value
>> not
>> exceeding a safe margin.
>>
>> The filament, if you watch the HV and follow guidelines,
>> will be right in the ballpark. This is why the manual
>> tells
>> you to set the tap to the next HIGHER voltage UP from the
>> maximum voltage you expect to see.
Watch the HV or pick the right taps, and the filament will
take care of itself.
73 Tom
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|