I tried that with a 3CX3000 amp and it didn't buy me much.
Bob
----- Original Message -----
From: "Will Matney" <craxd1@verizon.net>
To: <amps@contesting.com>
Sent: Thursday, May 25, 2006 10:02 PM
Subject: Re: [Amps] Quad Tube 4cx800 hf amp
> Manny,
>
> You can add a small amount of inductance between the coupling caps and
> Tune C to drop it thus making it a L-Pi circuit.
>
> Best,
>
> Will
>
> *********** REPLY SEPARATOR ***********
>
> On 5/25/06 at 9:50 PM Manuel R. Alonso / KC4MNE wrote:
>
>>Hello
>>
>>Would it be feasable to build a 4 tube amplifier using the 4cx800 russian
>>tubes.
>>
>>I calculated a plate impeadance of about 490 ohms, using (2600V 3.0 amp
>>supply)
>>
>>However for a Pi output I am looking at a c1 value of about 100 pf at
>>29MHZ and each tube has 51pf of capacitance already, if added together
>>thats over 200pf. How is this obstacle corrected?
>>
>>Manny
>>
>>KC4MNE
>>
>>_______________________________________________
>>Amps mailing list
>>Amps@contesting.com
>>http://lists.contesting.com/mailman/listinfo/amps
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|