Yep, the principle works from power supplies, audio and RF.
I believe Bill is the one confused.
Carl
KM1H
----- Original Message -----
From: "Jeff Blaine AC0C" <keepwalking188@yahoo.com>
To: <dezrat1242@yahoo.com>; <amps@contesting.com>
Sent: Tuesday, October 13, 2009 9:07 PM
Subject: Re: [Amps] Checking Plate Choke resonance
> Hi Bill,
>
> I am a bit confused on this.
>
> It's been a while - but I was thinking that I read one time on RM's site
> about creating an intentional parallel resonance on the filament choke.
> That's a different part, but it seems the principle would be the same.
>
> 73/jeff/ac0c
>
> --------------------------------------------------
> From: "Bill, W6WRT" <dezrat1242@yahoo.com>
> Sent: Tuesday, October 13, 2009 11:03 AM
> To: <amps@contesting.com>
> Subject: Re: [Amps] Checking Plate Choke resonance
>
>> ORIGINAL MESSAGE:
>>
>> On Mon, 12 Oct 2009 23:17:39 -0700, "Hardy Landskov" <n7rt@cox.net>
>> wrote:
>>
>>>Sweep
>>>the frequency range you want to use and watch for series resonances.
>>
>> REPLY:
>>
>> Watch for parallel resonances too. Either one will smoke the choke if
>> they
>> are
>> in or near a ham band.
>>
>> 73, Bill W6WRT
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|