Ok, got parts in and replaced most of the bias circuit. Now I have 9.7v on
the cathode on rx and 8.7v on tx. Would those be reasonable for bias when
cutoff and tx in ab2 operation for the pair of 3cx800a7's?? I have a
feeling the cutoff voltage is a bit low as I am seeing a bit of plate
current, at least its just barely moving the needle instead of the 400ma I
had before.
David Robbins K1TTT
e-mail: <mailto:k1ttt@arrl.net> mailto:k1ttt@arrl.net
web: <http://wiki.k1ttt.net/> http://wiki.k1ttt.net
AR-Cluster node: 145.69MHz or <telnet://k1ttt.net/> telnet://k1ttt.net
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|