Will
Rivet-nuts (we call them rivnuts at work) are very good means of fastening
hardware when it is difficult to attach with a regular nut. Our use is from a
10-32 screw into racks up to 3/6 for attaching racks to shelter walls. Grip
range from 0.020 to 0.250 inch.
We use mostly steel and have used stainless steel (think about 500 in each
item).
Depending upon the quantity you are going to use, please consider the "hand
header" that is made for attaching the rivnut. Its the best way, except for
the very expensive air drive tools we use (about $8000.00).
When you purchase a rivnut it is important to specify the material thickness
into which you will be using the rivnut. You will find a range in which any
specific part number rivnut can be used.
A rivnut when pulled up properly will expand behind the material it is inserted
into and it is this expansion against the back to the material that pulls the
head of the riv-nut against the front of the material.
For most uses I would suggest an open end rivnut, as this will accomodate any
length of screw you use. Closed end rivnuts are used when you want a water
tight attachment and then its dipped in an RTV to ensure a good seal around the
exterior of the rivnut.
After we install them we MUST perform a torque test and pull-out test to ensure
they are properly (in a truely QA fashion, a sample is selected) installed. If
anuyone needs detail info on that test I can advise them. If one spins its a
real bear to to rework of repair (yes, rework and repair are 2 different
animals-but thats a different discussion).
PEM nuts are installed using a press (we do lots of them also, and many
different types and also studs). Rivnuts are NOT installed with a press. A
BIG DIFFERENCE.
I have catalogs at work and if needed I could provide some info for you as to
the "grip" range you would require for your specific use. The grip range is
that value of pull-up a specific rivnut will accomodate (this translates into
material thickness).
We order such large quantities that we do not go to the smaller distributors
and as suggested McMaster Carr does carry a selection. Surely there are others
as well, I just happen to have a McMaster Carr catalog in my work file cabinet.
Pick the CORRECT rivnut and its a great product; pick the wrong one and its a
miserable product.
Hope this helpful. Possibly more than you expected, but I know other readers
might be interested as well.
Arne N7KA
-------------- Original message --------------
From: "Will Matney" <craxd1@verizon.net>
> All,
>
> Does anyone know a good supplier to buy rivet-nuts? These like the Atlas
> brand
> Spin-Tite rivet-nuts that use a tool similar to a pop-rivet gun to install.
> Either surplus or new will do, but I need to find a vendor who will sell in
> 100-500 quantity at a time. I'm starting to get my shop up and running doing
> some aluminum cabinets, etc, and want to use these as the fasteners. Any help
> would be appreciated.
>
> Thanks,
>
> Will
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|