On Feb 25, 2006, at 6:26 AM, Ian White GM3SEK wrote:
> R. Measures wrote:
>>
>> In my experiences, an RJ-1A will not do 50wpm without a speedup
>> circuit
>> to decrease its make time from c. 6mSec to 2mS. see
>> http://www.somis.org/D-a-07B.jpg
>
> It all depends how much character distortion you're prepared to
> tolerate,
The problem is hotswitching, not distortion.
> given that one dot at 50wpm is 30ms long.
>
> Many transceivers cannot do full QSK at anywhere near 50wpm either.
> This
> puts the squeeze on the amplifier designer, to avoid making a bad
> situation even worse.
As long as the amplifier can switch faster than the transceiver, there
will be no hotwitching.
>
> The critical timing is when switching from RX to TX, and the RF relay
> changeover isn't the only time delay involved. It's best not to switch
> the bias until *after* the relay has changed over and connected the
> tube
> to a safe load. So you then need time to switch the bias and let the
> tube settle to its new DC operating condition. To further reduce the
> risk of hot-switching or distortion of the keying waveshape from the
> transceiver, it would be prudent to add a safety margin of a few more
> milliseconds.
>
> Thus a 6ms delay in the relay can easily imply a total dead time of
> like
> 10ms or even more - which is a very significant fraction of 30ms. If
> 6ms
> can be reduced to 2ms, that would a very worthwhile improvement.
>
> Vacuum relays like the RJ-1A respond very well to speedup circuits that
> deliver a 'kick' of high current at switch on. Rich, Paul WD7S and I
> have all measured similar improvements.
>
> The speedup circuit I use was designed by K1KP and publicized by K6XX,
> and has the advantage that it works from the existing 24V rail. It also
> includes a fast PTT input that won't damage the solid-state PTT output
> of any transceiver.
> http://www.ifwtech.co.uk/g3sek/in-prac/best-of.htm#speedup
>
>
> --
> 73 from Ian GM3SEK
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|
