The method of keeping the oily goo off of the floor is identical as to how I
have done it for many years. Same heathkit Cantenna too.
73,
Gary...wa6fgi
>________________________________
> From: Jerry Kaidor <jerry@tr2.com>
>To: amps@contesting.com
>Sent: Thursday, June 14, 2012 4:54 PM
>Subject: [Amps] Dummy Load Blues
>
>Hello,
>
> To mess with amps, a good dummy load is a must. I went to my storage,
>and pulled out a Cantenna of unknown provenance that I had purchased about
>30 years ago at a flea market. Not knowing what was in it, I assume it's
>poisonous PCB transformer oil. I had kept the dummy load in a plastic bucket
>with a hole for the coax, sealed with coax seal. Now I figured I'd
>dispose of the old oil, clean it out, and put in fresh mineral oil. What
>a mess!
>
> OK, the old oil is gone; it'll be headed to the local hazardous waste
>dropoff. The guts are all washed out in hot water and detergent. The
>heathkit can is toast - rusty and leaking. The silver
>straps around each end of the resistor are broken. So I can reconstitute
>this thing with new silver straps ( luckily I have some silver sheet
>laying around ). And the can - can be replaced with an ordinary one from
>the paint factory. Only trouble with that is - 1 gallon paint cans are
>now *plastic*, not metal. I guess it'll still work, just the heat
>transfer won't be quite as good.
>
> I also scored a 250W load cheap on Ebay. Seller said it came out of a
>cell phone installation. I popped it open - the resistor is the size
>of a postage stamp! I was messing with one of my SB2-LA's, used that
>load - figured a momentary toot from the amp wouldn't hurt it. I was
>wrong. Apparently these little resistors are not only heat limited,
>but *voltage* limited. I hit transmit, there was a small *pop* and a
>puff of smoke. Hole burned right through it.
>
> There are similar load resistors on sale on Ebay - 800W for IIRC $40.
>But that's just the resistor, you have to bond it to a heatsink. I
>have
>the heatsink from the defunct 250W load - I could machine off a big enough
>flat spot for the 800W resistor.... failing that, I have a really big heat
>sink in my junk.
>
> - Jerry Kaidor, KF6VB
>
>
>
>
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|