Hello Steve,
Monday, September 19, 2005, 10:25:49 PM, you wrote:
SK> It's not normal for the LOAD cap to be fully meshed on any band when
SK> operated into a 50 Ohm load. On 80m, a 500pF (I think) padder is switched
SK> in parallel with the tunable LOAD capacitor, but it's not in the circuit on
SK> 40m or the higher bands. If that cap were missing or bad (or the switch
SK> wasn't making contact in that position), that could explain why the LOAD cap
SK> needs to be fully meshed on 80m, but it wouldn't explain 40m...-WB2WIK/6
I had the same thought about 80 and the extra 'C' and changed it out
for a new one, I also tried increasing it's value and checked the
switch out but although everything was fine I still get the problem.
I've also tried switching the valves around, I have a spare set and
that did nothing at all either. You can see why I'm confused!
--
Best regards,
John mailto:kvp@bigfoot.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|