Amps
[Top] [All Lists]

[AMPS] resistors

To: <amps@contesting.com>
Subject: [AMPS] resistors
From: measures@vc.net (Rich Measures)
Date: Sat, 20 Feb 1999 05:43:15 -0800


>
>  Last time I did this I used a piece of an old
>fiberglass fishing rod (the large end) and ran
>it through the resistors leaving about 3/4" extending
>on each end and then clamped the ends onto standoffs.
> On just about every alpha 77 I've worked on I've found
>some arc damage from the bleeders to the mounting bolts,
>don't like that method.
>
>Mark  WB8JKR
>
?   Good point.  Through-bolt mtg. also blocks cooling air.  100k 
wirewound resistors are known to have a high failure rate.  If I wanted a 
Reliable bleeder for a 4kV C-filter supply, I would series up 8 to 10 
Matsushita/Panasonic 100k-ohm, 3w MOF resistors on a piece of perfboard 
and be done with it.  

>On Sat, 20 Feb 1999 10:11:49 -0800 "Ron Spencer" <n4vos@mis.net> writes:
>>
>>Hello I need some help here. I working on the power supply for the 
>>8877 tube. The question I have is how to mount the bleeder resistors
>>I have two ohmnite about 7 inches long, they are 100 watt 100k which 
>>will be in series. Can I use a thur bolt ? or would this be two risky ?
>>
>>Ron n4vos@mis.net



Rich...

R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures  


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>