Perhaps you might try changing the coax from the exciter to the amp
including changing the length of that piece of coax.
In a message dated 1/25/2010 1:11:21 PM Eastern Standard Time,
taurusshoguy@yahoo.com writes:
Gentlemen:
I have a very pleasant looking 2K Classic desktop in the shack for a bit,
and I am seeing a fairly high input SWR on all five bands. The low point is
20 meters with 1.7 to 1, and the high point is 10 meters at 2.5 to one.
Of the few issues I have seen with the Classic Series of Henry amps through
the years, input SWR was never an issue.
I am hoping that readjusting the input coils or possibly a dirty/defective
input relay are my remedy.
I would appreciate input from folks who have conquered such an issue
especially on a Henry.
TIA Don N8ECH
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|