Amps
[Top] [All Lists]

[AMPS] Glitch Resistors

To: <amps@contesting.com>
Subject: [AMPS] Glitch Resistors
From: 2@vc.net (2)
Date: Wed, 12 Sep 2001 07:12:02 -0700
>
>Can I re-post this for comment from more experienced builders ??
>It seems OK, but maybe I'm missing something  12/09/01
>
>
>
>To add further to the debate...which I might add is very interesting and
>informative, what is the general opinion in using a replacement jug element
>??
>
>To elaborate, down here in VK land, we have jugs ( kettle's, urns etc) that
>use a wirewound element on a ceramic former. They are rated at 240v,
>1600watt and cost about $3.50 AUD. They measure about 40 ohms and consist of
>a length of nichrome (??) spiral wire wound on a ceramic former that is
>about 55mm long, 30mm wide and about 5mm thick. It comes with two long
>stainless steel rods fitted that allow it to be mounted in the jug, but
>these are easily removed and you end up with a 40 ohm wirewound resistor on
>a ceramic former. The whole thing is obviously exposed but can be easily
>mounted on standoff insulators inside a supply.
>
>Is this thing useable as a glitch resistor ??
>
If the air-gap between turns is c. one wire diameter, it should fly.
>
cheers, Glenn


-  R. L. Measures, 805.386.3734, AG6K, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>