>>that uses a pair 3cx800. About a minute or so after I first turned it on
>>[nothing hooked to it but the power cord] I heard a very loud bang. So I
>>shut if off and inspected for damage. Nothing found.
>>
>>While reading the manual imagine my surprise to see the bang
>>mentioned, said to not be that uncommon, and not to worry about it unless it
>>starts happening often--then replace the tube.
>
> I'm an appliance operator, here to learn ... but I can't help commenting
>on the above. What kind of an amp manufacturer says "It'll bang sometimes
>when you turn it on; if it happens a lot, replace the $350 tube."?
** On p.14, Kenwood's TL-922 manual talks about "normal arcing" in the
tank. Those with access to a spectrum analyzer know that normal arcing
and bangs coincide with a signal intermittently being generated at c.
120MHz. If not corrected, "normal arcing" will eventually destroy the
5kV Sagadenki® bandswitch and/or cause grid/fil shorts.
>Apparently the answer to that is Ameritron. Is this a common practice??
>
** Not Invented Here syndrome is undoubtedly a common practice.
> My ACOM 1000 manual certainly says no such thing ... nor does the amp
> make
>any noises at all.
>
As I understand it, ACOM does not use High-VHF-Q parasitic suppressors.
cheers, Gene
>
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
- R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
www.vcnet.com/measures.
end
|