Hello all I have a clipperton L
that seems to have a problembut not sure if it is
tubes or other.
Here is the deal
On 160M I get 175watts
On 80M I get 200
40=200
20=500
15=500
wired for 110v
The plate voltage is there during tune up (1800V)
But it is seems that it is not drawing the current or
maybe not enough drive. My radio only puts out 80
watts on all bands (FT100D)even at 500watts on the 2
bands it still did not get to the (660ma0 (1Kw) input
according to the book plate voltage only dropped to
1700v I would figure it should have dropped more than
that.
Any suggestions??
PS all test were done into a oil filled 50 ohm dummy
load 5 second burst on tune up..
Thanks
David KR4OW
__________________________________
Yahoo! Mail - PC Magazine Editors' Choice 2005
http://mail.yahoo.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|