Amps
[Top] [All Lists]

Re: [Amps] Eimac tube on the 'bay

To: Roger <sub1@rogerhalstead.com>
Subject: Re: [Amps] Eimac tube on the 'bay
From: Alek Petkovic <vk6apk@bigpond.com>
Date: Tue, 13 Oct 2009 07:26:50 +0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
No, the amp deck we are modifying is the driver amp or IPA from the 
10kW Technical Materiel Corporation, 10kW transmitters. The same 
units can be seen in photos of the WWV site. We have,what used to be 
a US Navy communications base here in Western Australia,located at 
North West Cape. These units were used there and became surplus and a 
heap of local hams were able to get hold of them. This was about 20 
years ago and there a still quite a few floating around.

The amplifier module uses a 6CL6 followed by a 6146W followed by the 
8295A. From memory, with that lineup, we used to run 100mW into the 
front end and get our 1500W out at the tail end. It was of course a 
real chore to change bands with that setup so we did away with the 
first 2 stages and stuck 50 Ohm at the grid of the 8295A and so we 
were able to feed in 100W and only have to do the output tuning when 
we changed bands. The grid was biassed at -120V so with 100W drive 
into the 50 Ohms, we never went into grid current.

We, (my local club) decided to strip one of these units down (donated 
by VK6JX) and just use the RF deck in a new enclosure and plonk a 
GS35B into it. It is a works in progress and we hope to have it on 
the operating desk by Christmas this year.

That is why we have the tube, socket and chimney surplus. They are 
now sold and will be heading to a new home in Florida this week.

On the subject of the bigger tube, we are also stocked up with all 
the parts necessary to build a YC156 amp. This will be for 80, 40 and 
20m only. This project will commence immediately after the GS35B is built.

Cheers from soon to be sunny, Perth
Alek. VK6APK



At 06:58 AM 13/10/2009, Roger wrote:


>Alek Petkovic wrote:
>>I have a good tested one (8295A) here out of VK6JX's TMC amp. It 
>>comes complete with SK184A socket and chimney. It was doing 1.5kW 
>>out when last fired up.
>>
>>We are doing a GS35b conversion
>To an HT-33B?
>
>>and so the tube, socket and chimney are surplus.
>>
>Not the GU-73BB? It and the socket are a *little* more money, but it 
>is certainly capable of surpassing a few GS-35Bs <:-))
>
>73
>
>Roger (K8RI)
>>Any offers?
>>
>>73, Alek
>>VK6APK
>>
>>
>>At 02:35 PM 12/10/2009, Roger wrote:
>>
>>
>>
>>>Roger wrote:
>>>
>>>>Larry wrote:
>>>>
>>>>
>>>>>    I wouldn't recommend powering up the HT-33b though, or you may be
>>>>>returning to the restoration bench... Larry
>>>>>
>>>>>
>>>>>
>>>>Yah, it looks like some of those pits are pretty deep and PL-172s are
>>>>notorious for going gassy while the 8295As have a good reputation. Maybe
>>>>that's why a good tested 8295 runs twice the price of a good tested PL-172.
>>>>The PL-172s have a designator of PL-172/8295A, but the true 8295A is
>>>>metal ceramic while the 172 is metal with glass seals.  Neither one goes
>>>>for much (on average) untested.  OTOH I sometimes see some untested "as
>>>>is" tubes go for far more than I'd pay.
>>>>
>>>>
>>>I should add that the 8295A is relatively rare and when found in tested
>>>and in good shape are worth a small fortune.  In addition to being
>>>metal/ceramic they are about a 1/2" taller than the glass/metal PL-172
>>>
>>>73
>>>
>>>Roger (K8RI)
>>>
>>>>73
>>>>
>>>>Roger (K8RI)
>>>>
>>>>
>>>>
>>>>
>>>>>-----Original Message-----
>>>>>From: Roger [mailto:sub1@rogerhalstead.com]
>>>>>Sent: Sunday, October 11, 2009 10:16 PM
>>>>>To: n1miw@cox.net
>>>>>Cc: amps@contesting.com
>>>>>Subject: Re: [Amps] Eimac tube on the 'bay
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>Larry wrote:
>>>>>
>>>>>
>>>>>
>>>>>>    Looks like this tube didn't sell the first time, so he's trying
>>>>>>
>>>>>>
>>>>>>
>>>>>again...
>>>>>
>>>>>
>>>>>
>>>>>>Anyone have a sandblaster? Should clean up nicely with one of
>>>those! I bet
>>>
>>>>>>the vacuum would need to be "put back in" though! :-)   ...Larry
>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>http://cgi.ebay.com/EIMAC-TUBE-8295-PL-172-Hallicrafters-Amp-more-NR_W0QQite
>>>
>>>>>
>>>mZ370270597830QQcmdZViewItemQQptZVintage_Electronics_R2?hash=item5635d8f2c6
>>>
>>>>>We were talking about that one over on the Hallicrafters group last
>>>>>week.  I thought it'd make a good, colorful addition to a restored
>>>>>HT-33B while keeping it all original.  Don't spose that one had a bit of
>>>>>exposure to salt water or was left in wet packing for "some time"?  It
>>>>>was also labeled another hurricane casualty.
>>>>>
>>>>>73
>>>>>
>>>>>Roger (K8RI)
>>>>>
>>>>>
>>>>>
>>>>>>_______________________________________________
>>>>>>Amps mailing list
>>>>>>Amps@contesting.com
>>>>>>http://lists.contesting.com/mailman/listinfo/amps
>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>>>
>>>>_______________________________________________
>>>>Amps mailing list
>>>>Amps@contesting.com
>>>>http://lists.contesting.com/mailman/listinfo/amps
>>>>
>>>>
>>>>
>>>_______________________________________________
>>>Amps mailing list
>>>Amps@contesting.com
>>>http://lists.contesting.com/mailman/listinfo/amps
>>>
>>
>>
>>http://www.qrz.com/db/vk6apk
>>http://www.qrz.com/db/vk6py
>>
>>
>>_______________________________________________
>>Amps mailing list
>>Amps@contesting.com
>>http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>
>
>http://www.qrz.com/db/vk6apk
>http://www.qrz.com/db/vk6py
>

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>