> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]
> On Behalf Of Bill, W6WRT
> Sent: Friday, March 19, 2010 9:56 PM
> To: amps@contesting.com
> Subject: Re: [Amps] placement of RF choke bypass cap.
>
> ORIGINAL MESSAGE:
>
> On Fri, 19 Mar 2010 19:22:28 -0400, Roger <sub1@rogerhalstead.com>
> wrote:
>
> >
> >I can say with certainty that an RF signal from VLF through UHF applied
> >to the inside of that wall, did not make it to the outside of that
> wall.
>
> REPLY:
>
> If you are talking about RADIATED energy, I agree, no doubt about it.
> But our discussion is about CONDUCTED energy.
>
> So are you telling me that if you mounted a double female bulkhead
> coax connector to the screen and fed RF energy into it, there would be
> nothing getting to the other side? Or that only energy from the center
> conductor would go through and the shield side would not?
>
> I find that hard to believe.
>
> 73, Bill W6WRT
Same thing Bill, radiated energy when intercepted by the screen will put
currents into the screen on the side where the energy is and current will
flow on that surface.
Putting a connector thru the screen will pass energy as it would thru any
coax line. The center conductor and the inside of the shield.
73
Gary K4FMX
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|