Yes all that you mention below is correct Jim. That's why I commented in an
earlier post that an individual QRO amp builder would get away with doing
this questionable 3 kW power supply realization technique, but no commercial
SS amp manufacture would be able to do this due to the electrical codes in
respect of EU power factor rules and product compliance certification.
The above comment is made notwithstanding Manfred's keen advocacy for
building a direct mains powered isolated RF power amplifier this way. I
think we can concede if done competently it would be safe enough when
sufficient caution is exercised during testing...as we all do with our
potentially lethal 3+ kV tube amplifiers!
Leigh
VK5KLT
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Jim Brown
Sent: Tuesday, 24 September 2013 1:38 AM
To: amps@contesting.com
Subject: Re: [Amps] Direct rectification of AC mains to drive the amp,
On 9/22/2013 10:10 PM, Jim Thomson wrote:
> Has anybody actually measured the PF on a transformerless supply, with
> a big C filter ???
> I cant see it being any worse than your typ kw tube amp....with the
> typ xfmr + FWB / Doubler + high C filter.
No, but the issue is not reactance, it is the fact that current is not
sinusoidal, but rather is drawn in pulses at the peaks of the cycle to
charge that cap. Back when most of us went to school PF was simply
related to the phase angle between the sine wave of voltage and the sine
wave of current. Now, the definition of PF has been expanded to include
that impulsive current.
Also the current is impulsive,so it is rich in harmonics, and "triplen"
harmonics add in the neutral of 3-phase systems. Because the loads on
electrical systems are now dominated by equipment of all sorts with
capacitor-input filters, and triplen harmonics add in the neutral of
3-phase systems, it has become all too common for currents in the
neutral of 3-phase systems to be equal to or greater than the phase
currents. Remember "the towering inferno?? The cause was overheating
neutrals, and flames were burning insulation that spread up raceways.
In EU, power factor is regulated by electrical codes. In North America
it is not, although I think I've heard that power companies may offer
discount rates for maintaining a better PF.
73, Jim K9YC.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|