Roger,
The 43 dB applies at 2.5 times the necessary bandwidth away, or for SSB, at
about 7.5kHz away from the centre of the transmission. I would like to send you
the results of the measurements of SM5BSZ which show only one rig meeting the
requirement....the FT1000D, but my ISP won't allow sending emails over 3Mb.
73
Peter G3RZP
========================================
Message Received: Oct 09 2013, 06:17 PM
From: "Roger (K8RI)" <k8ri@rogerhalstead.com>
To: amps@contesting.com
Cc:
Subject: Re: [Amps] Regulations
On 10/9/2013 12:07 PM, peter chadwick wrote:
> Manfred,
>
> Chile would seem in practice to be not that much different to most other
> countries!
<snip>
>Note that the FCC translation of SM329 into Part 97 managed to omit
>the 10 log P, so it's 43dB in the US.
Apparently this doesn't include IM3 as I think few amps, or even rigs
sold in the US have an IM3 as good as 43db or did I miss something.
I think QRO builders, "in general" have cleaner signals than the
commercial amps.
A note on ID in the US, on short transmissions, 3 minutes or less as on
many repeaters you normally hear the users ID only every 10 minutes.
Break-in CW is usually just BK with the ID every 10.
73,
Roger
> One thing I do think that as amateurs we should do is to try to ensure that
> home brew equipment
meets the relevant ITU standards on spurious emissions, although I grant
that for QRO at 10GHz on
CW, that's impossible. For HF, harmonics and spurs (unwanted sidebands
from a switching supply
perhaps?) should be 43dB + 10 log P dB down from PEP, without needing to
be more than 50dB down.
Note that the FCC translation of SM329 into Part 97 managed to omit the
10 log P, so it's 43dB
in the US. While amateurs are seen to be complying (i.e. not causing
trouble), we are more likely
to be left alone. Having said, that amateurs hadn't caused problems but
ITU TG1/3 revised SM329
in 1993 - 5 and brought amateurs in for the first time, anyway.
>
> My rig uses a VFO, is very good on phase noise, rx and tx IMD and is 30
> years old.....so I don't
feel I'll change that!
>
> 73
>
> Peter G3RZP
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|