Hi Steve:
I am pretty sure you are the proud owner of at least one tube with a grid to
cathode short. Since the filaments are wired in parallel, you can remove
(carefully) one tube at a time, and see which one is causing the issue. You
don't want to operate it this way for long though, as besides the obvious plate
current issue, the filament xformer will burn up in short order.
Unplug the AC cord before you open it up, and remember to (safely) short one of
the tube anode connectors to ground before touching anything inside the tube
compartment.
You can make the job easier by placing a non conductive item between the HV
shorting bar and ground, which will allow you to fire it up with the top open.
Be VERY careful during this process though, and make darn sure the HV has bled
away before touching anything inside again When you find the tube that has no
plate current in stand by, that's the good one.
If needed, you can run it on one tube, but of course the plate/load settings
will be different, and output will be less. Also, be sure that the missing
tube's plate connector won't short out to anything when you fire it back up on
one bottle.
Before you button it back up, don't forget to remove the item you installed to
disable the HV shorting bar.
Don N8ECH
On Monday, October 5, 2020, 02:03:49 PM EDT, Steve AA7V
<aa7victor@gmail.com> wrote:
Hello to the group;
My SB220 has started to act up.
Immediately upon power on, the 3-500s both start drawing plate current. The
meter shows approximately 250 ma of current. It is apparent some component
has failed.
Also, it appears the grid current meter is showing a negative value (if
this is possible) as the needle now rests on the left peg.
I am not adverse to troubleshooting to the component level but would
appreciate any advice as to how to narrow my search to a specific set of
probable causes.
If I am unable to fix this amp, does anyone have any recommendations
towards a person that works on SB220s?
Regards
Steve AA7V
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|