ORIGINAL MESSAGE:
On Tue, 26 Oct 2010 17:30:49 -0400, "Carl" <km1h@jeremy.mv.com> wrote:
>
>A 6 mix iron powder is good for 6-10M, I use it as the L in the input pi
>network for amps. If it works for you for HF RFI than thats good, Id guess
>it wasnt too severe and just a little bit of impedance did the job.
REPLY:
The Palomar data sheet says #6 is good for 2-30 MHz.
http://www.palomar-engineers.com/Iron_Powder/iron_powder.html
Where did your informaton come from? Perhaps different manufacturers use
the same number for different mixes?
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|