At 06:57 AM 3/24/98 -0800, Phil wrote (I think - these multi-layer quotes
are confusing):
>>Your SWR does not change enough to see it because as you lower the input
>>power, you also lower the cathode current, maintaining about the same
>>input impedance. Try this...tune up your amp and apply 100 watts drive.
>>Note the cathode current. Reduce the drive to 50 watts. The cathode current
>>should be close to 1/2 what it was at 100 watts input. Since input impedance
>>equals drive power divided by peak cathode current squared, you can see how
>>the input impedance stays fairly close throughout the operating range. The
>>low Q of the tuned input L/C allows compensation for any variations in the
>>drive/cathode current ratio.
I don't know the theory, but on my SB-220, when I run it on 24 MHz I
usually use the autotuner on my TS-930 to match the input network. As I
tune the final, the autotuner senses a change in the input SWR (I can see
it on the 930's SWR meter as well) and responds by retuning. So both it
*and* I are seeing the change.
73, Pete Smith N4ZR
n4zr@contesting.com
"That's WEST Virginia. Thanks and 73"
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|