About half of that will be right.
Voltage swing is less then 2.2KV, and the conduction angle is not 360°.
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Steve Katz
Sent: Freitag, 26. September 2008 20:42
To: jerome schatten; Amps
Subject: Re: [Amps] gg amp question...
R = E/I = 2200/.4 = 5500 Ohms.
Close as you're gonna get.
-WB2WIK/6
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of jerome schatten
Sent: Friday, September 26, 2008 11:41 AM
To: Amps
Subject: [Amps] gg amp question...
I'm trying to modify my pi network on a pair of gg 813's to work on 160.
Looking back into the plate circuit from the pi network, how to estimate the
ac plate circuit impedance that needs to be matched by the pi network?
My handbook has a series of tables (11 of them) for determining C(load),
C(plate) and L for various values of Z(plate) for each band.
Basically it's a 10db amp that runs ~450w out with 2200v on the plates and
key down Ip of 400ma
Thanks for your insight,
jerome - VA7VV
--
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|