Never could understand why a design would not connect B- direct to
chassis. Unless it was they figured they could use cheap meters to
measure anode current. I'm for puttin' the anode meter in the anode B+
line where it belongs.
73
Bob K4TAX
Mark S Graalman wrote:
>
> I just got a LK-500ZA in for repair, the bypass cap
> at the plate choke had failed and it took out the
> grid shunt. According to the paperwork I have on this
> amp the values of the shunts are simply "factory selected"
> does anyone know what the value is? If not, I guess
> I'll have to do it the hard way.
>
> What a crap design, no method used to prevent
> the B- from rising above chassis ground in case of a B+
> short.
>
> Mark WB8JKR
>
> ________________________________________________________________
> YOU'RE PAYING TOO MUCH FOR THE INTERNET!
> Juno now offers FREE Internet Access!
> Try it today - there's no risk! For your FREE software, visit:
> http://dl.www.juno.com/get/tagj.
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|