>>> http://www.g8wrb.org/data/Eimac/3CX1500A7.pdf
>> As well as a data sheet with airflow figures, you can also find an
>> article describing how to estimate what flow/pressure a blower will
>> produce. In general, CFM ratings are not a useful guide - you need to
>> know if a blower will produce enough pressure.
> Umm, beg to differ. What actually provides the heat transfer is the
> mass flow rate of air (grams per second) and its specific heat.
> Unfortunately the mass flow rate of a gas is very difficult to measure.
I don't think we differ. What I meant was that blower cfm ratings
alone are not a useful guide to suitability for a given valve. First
you have to establish if the blower can produce the pressure - then
you can see if there's enough volume/mass flow. Blower cfm ratings are
nearly always into free air, which tells you nothing about the 'load
line'. I have a lovely snail blower with a fancy cast housing and so
on. From memory it's rated at close on 300cfm - but feed it through an
8877 and you're hard pushed to feel any air flow coming out.
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|