Hi all,
I need some advice from you more experienced guys....
I've been building on my 811a amp for some months now and I'm reaching quickly
the point of the "big" test. Every section of the amp has been tested with only
low voltages and I basically only had one more test to perform before applying
HV and some watts of drive. The test I was about to perform today was applying
only filament to the tubes and no HV. The idea was to run the NOS 811:s for a
couple of hours with only filament before applying the HV.
The test went very well in the beginning; all tubes lit up and I measured 6.35
volts at the pins on the tube. I noticed some heat in the filament choke, but
the temperature leveled out on 38 degrees (Celcius that is, sorry F-guys). But
after about an hour the amp went dead with blown fuses and a burnt step start
resistor. Having checked everything in the circuit it would appear that the
transformer shorted, or broke. The transformer is most likely dead as a result
of this test. If I apply about 10 volts AC to the primary, I get 1,5 volts in
the HV secondary instead of 47 volts, which I had before, in previous tests.
My questions are:
1, What would have caused the transformer to melt down? Or perhaps brake down?
I only had filament and control circuits hooked up. No HV = not connected to
the bridge board.
2, Can old, NOS 811a cause this by shortening its filament? And would you
advice against NOS tubes? Should I go for chinese instead?
3, How can I protect my transformer in the future? Obviously the fuses in the
primary was not enough to protect the transformer.
The transformer, by the way.. is an original Ameritron 811H.
I can also offer some pictures here: http://gallery.me.com/ulf.tjerneld#100183
The last pictures are a couple of months old. More has happened since then.
They may not give a clue to what happened but they give you an idea of the
level of standard with which I have carried out the project.
Thanks! Happy for any advice before I get out for a new transformer!
73's
Ulf (SM0NOR)
ulf@sm0nor.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|