Date: Tue, 22 Oct 2013 18:11:26 +0200
From: "Peter Voelpel" <dj7ww@t-online.de>
To: <amps@contesting.com>
Subject: Re: [Amps] 200-ohm tank and "un-un" in HF amp design?
&&&& so what ? The point is no single 8877 is gonna require
a whopping 3 uh b4 the main 10m Pi-net to get it to work on 10m.
Maybe .3 to .5 uh. BTW.. there is one helluva lot of current in that coil b4
the main
pi net..and also the main 10m coil. Both need to be made of an appropriate
sized tubing...or strap.
&& For folks that want to parallel 2 or more bandswitch wafers to handle more
current....esp for the upper bands, there is a right..and wrong way to do it.
Aside from paralleling the COMS..and each bandswitch contact... you have to
strap
the input + output correctly. Wafer closest to the coils does all the various
taps.
The COM on the wafer that’s furthest away from the coils is the output..and
goes off to the
load cap. IE: In on wafer #1...and out on the COM of last wafer. Done that
way, the current
will divide equally between all wafers. IF instead you tap on wafer #1 and
exit on the COM of wafer
#1... you will end up with 95 % of the current flowing through wafer
#1...cooking it.
&& You would be surprised how many get that wrong. Same principle is also
applied to paralleling
anything to handle more current, like diodes, caps, etc. If you draw out the
above multiple wafer
setup described above..the principle is to have a total combined input +
output length between
each device to be paralleled. IE: 1 inch to the input of diode #1....and
a 4 inch output lead to diode #1.
Diode #10 gets a 4 inch input lead....and a 1 inch output lead.
&& If you want more eff on upper bands.. on a GG amp... install a 100 pf NPO
cap between
chassis and cathode. This increases the cathode to grid C by 100 pf. That
will require
a slight tweak on the C2 cap of the tuned input. The improvement in eff is
well worth it.
Jim VE7RF
Who talked about a YC-156?
There are tubes with less capacitance around.
The coil value depends on the tube capacitance.
73
Peter
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Jim Thomson
## No way in hell is 3 uh gonna work for the lead inductance. That
circuit is commonly called a L-PI. Typ coil values are .3 to .7 uh.
And no, it doesn't make the amp unstable. A buddy recently completed
a 80-10m YC-156 GG amp. Now that tube is 35 pf from anode to grid..
and rises to 50 pf when the grid flange is bolted to the chassis.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|