This buzz is common. Often you can hear it in your shack but it is not
going out to the antenna.
It is most irritating when using direct conversion receivers. The BFO of
the receiver finds its way to the
power supply where the rectifier diodes modulate it at 120Hz rate as they
switch on and off and then it
gets reradiated and picked up by the receiver again. Capacitors across the
diodes usually cure that problem as
well.
73
Bill wa4lav
At 11:52 AM 3/3/2009 -0500, ToddRoberts2001@aol.com wrote:
>Back when I first started building some low power transmitters
>I always seemed to notice a slight hum or buzz superimposed on the
>carrier until I bypassed the power supply diodes with .01 caps across
>each diode. I also seemed to notice RF getting into the AC house
>wiring that was also cured by adding .01 caps across each rectifier.
>
>Likewise I have run across some solid state and tube receivers that had a
>buzz
>superimposed on reception especially at lower frequencies. The buzz was
>cured when .01 caps were added across the power supply diodes.
>
>73 Todd WD4NGG
>**************A Good Credit Score is 700 or Above. See yours in just 2 easy
>steps!
>(http://pr.atwola.com/promoclk/100126575x1219957551x1201325337/aol?redir=http:%2F%2Fwww.freecreditreport.com%2Fpm%2Fdefault.aspx%3Fsc%3D668072%26hmpgID
>%3D62%26bcd%3DfebemailfooterNO62)
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|