ya
<http://www.angelfire.com/nb/ni4l/gu84b.html>
http://www.angelfire.com/nb/ni4l/gu84b.html
Look down at the ONE tube schematic.
This is the only one I have seen for HF so far that's not too convoluted.
-----Original Message-----
From: Bill Turner [mailto:dezrat1242@ispwest.com]
Sent: Monday, January 30, 2006 11:11 AM
To: Partain, Chuck; amps@contesting.com
Subject: Re: [Amps] cathode to ground in tetrode amp
ORIGINAL MESSAGE:
At 07:14 AM 1/30/2006, Partain, Chuck wrote:
OK, getting into this more and more every day and learning. Looking at some
designs on this GU-84b
amp, I see a lot if not most of the cathodes have resistance, some a lot(30k)
some little (.7) to ground.
The screen grid and control grids are not grounded and have respectively ~350
and -150v on them.
Why wouldn't it just essentially go to ground? what does the R do in series?
thanks as always.
KA1MWP
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Is there a schematic we could look at?
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|