Thanks for the replies.
Notables are:
(1) Higher loading cap voltage (Gold Star Winner)
(2) Loss, and what to do with the heat
(3) Cost
Thanks and 73,
Jim N7CXI
---------
Assuming adequate core/wire sizing and airflow, can anyone think of a
solid reason *not* to design a legal-limit HF amp output tank for 200
ohms, then use a 4:1 "un-un" transformer to step it down to 50?
I'm curious because doing so would bring the loading cap requirement for
a 4000-ohm plate impedance down to under 1000pF at 1.8 mHz, which can be
done with a large air variable alone.
Note: Yes, I know it *has* been done already, but I'm asking for
opinions as to whether you think it should be.
Thanks and 73,
Jim N7CXI
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|