I have been asked to look into the possibility of remote monitoring an
SSPA at a distance of a little over 50m. My feelings are that ethernet
is the way to go. I will need to monitor supply voltage and current,
forward and reflected power, drive power and a few fault conditions. Are
there any ready made configurable solutions all ready out there?
I do not expect there to be problems with RF fields as it is a 1kW on
23cms and there should not be much spill over from the dish. Of course
it must be quiet so as to not disturb the weak signal RX.
Any advice appreciated.
--
__________________________________________________
73
Conrad G0RUZ IO93FR
North Wakefield Radio Club
__________________________________________________
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|