To: | Vic Rosenthal <k2vco.vic@gmail.com> |
---|---|
Subject: | Re: [Amps] peak voltage rating for load cap |
From: | Alek Petkovic <vk6apk@bigpond.com> |
Date: | Sun, 20 Aug 2017 07:17:41 +0800 |
List-post: | <mailto:amps@contesting.com> |
Ha! You're right. Sorry 'bout that. I'm a quick reader. Not a good reader. :-) 73, Alek. VK6APK On 19/08/2017 10:52 PM, Vic Rosenthal wrote: All of you guys are forgetting that he said "PI-L", not PI! Vic 4X6GPOn 19 Aug 2017, at 16:29, Peter Voelpel<dj7ww@t-online.de> wrote: Let´s say the SWR is 3 then the load might be 150 ohms. The peak voltage across the load capacitor will be 775V at 2KW. That is sqrt3 higher then at SWR1. 73 Peter -----Original Message----- From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Joe Subich, W4TV That will give you average (RMS) voltage with SWR = 1:1. For peak voltage, multiply by 1.414 (peak voltage of a sine wave): 316 * 1.414 = 447 V.Your 1200V capacitor will do the job with adequate headroom., when your system is all tuned and matched.Multiply the peak voltage by the SWR for worst case peak voltage if the voltage node occurs on the capacitor - 316 * 1.414 * 3 = 1340V. A 1200 volt rated capacitor will be marginal in a *system* allowing for a maximum SWR of 3:1 at 2 KW - it will be barely adequate when the system is designed for 1500 W (1166 V). _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps_______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps -- From sunny Binningup Our new house. https://17coronation.wordpress.com Family Businesses: SP Electrical. www.spelectrical.net.au The Velvet Fox. www.facebook.com/TheVelvetFox Smart Design Electrical. 0417 602 032 Perth Interiors. https://www.instagram.com/perthinteriors/ --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
Previous by Date: | Re: [Amps] peak voltage rating for load cap, Peter Voelpel |
---|---|
Next by Date: | Re: [Amps] peak voltage rating for load cap, Manfred Mornhinweg |
Previous by Thread: | Re: [Amps] peak voltage rating for load cap, Conrad PA5Y |
Next by Thread: | Re: [Amps] peak voltage rating for load cap, Conrad PA5Y |
Indexes: | [Date] [Thread] [Top] [All Lists] |