Amps
[Top] [All Lists]

Re: [Amps] Adhesive for Teflon sheet..

To: <garyk9gs@wi.rr.com>, <amps@contesting.com>
Subject: Re: [Amps] Adhesive for Teflon sheet..
From: "Paul Kraemer" <elespe@lisco.com>
Date: Wed, 23 Mar 2011 11:26:50 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Or just go to Home Depot and get a roll of double stick carpet tape
I've used it to stick together nylon plates used for assembly spacers
Once stuck it is STUCK. Adds about 0.006" per layer.
Paul K0UYA
----- Original Message ----- 
From: "Gary K9GS" <garyk9gs@wi.rr.com>
To: <amps@contesting.com>
Sent: Tuesday, March 22, 2011 6:33 PM
Subject: Re: [Amps] Adhesive for Teflon sheet..


> Hi Bob,
> 
> I work for an electronics manufacturing company and we have a guy 
> working for us that is really good at addressing this kind of question.  
> I asked him and he came up with a possible idea.
> 
> We use a Brady Corporation brand tape on our factory floor for marking 
> where things need to go like carts, parts bins, etc.  This tape is about 
> two inched wide and very durable since it's subject to a lot of traffic 
> and wear.  He actually took a small square of Teflon sheet and applied 
> the tape to it.  Before doing so he cleaned the Teflon with a solvent to 
> remove any oils or mold release that might be present.  His thinking was 
> that Brady probably offers a double sided tape using the same adhesive 
> as used on the floor marking tape.
> 
> As long as you're not looking for a lot of tensile bonding strength (the 
> tape was still able to be peeled off on the sample he prepared) this may 
> be a solution to what you're looking for.  The bond is quite strong in 
> shear.
> 
> Here's a link to the Brady web site:
> 
> http://www.bradycorp.com/
> 
> They do sell internationally.
> 
> This may be a better, safer and cheaper alternative than some of the 
> other suggestions.  Although the bond-able Teflon sheet someone else 
> mentioned looked interesting too.
> 
> Good Luck!!
> 
> On 3/21/2011 6:10 PM, Robert Briggs wrote:
>>
>> Thank you for all the replys both here and email...I have enough
>> information now and will be able to get on with the amplifiers...I am
>> doing a couple of 70cm units for EME work using the GS-31B tubes .
>>
>> 73...Bob VK3ZL..
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
> 
> -- 
> 
> 
> 73,
> 
> Gary K9GS
> 
> Check out K9NS on the web:  http://www.k9ns.com
> Greater Milwaukee DX Association: http://www.gmdxa.org
> Society of Midwest Contesters: http://www.w9smc.com
> 
> ************************************************
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>