The only ones I have are single-conductor unshielded. You use HV wire,
strip the insulation off for 1/2" or so, push it through the center pin,
pull the end of the wire so the insulation goes inside the connector as far
as it can go, and solder the conductor to the pin. Clip off any excess,
file it smooth to avoid any sharp points, and use it. The female connector
has a conventional solder lug.
WB2WIK/6
-----Original Message-----
From: aborg [mailto:a_borg@yahoo.com]
Sent: Monday, May 16, 2005 8:56 AM
To: Amps Amps
Subject: [BULK] - [Amps] Millen High Voltage Connectors
Hello Amper's,
What is the proper way to connect and wire the
millen red high voltage connectors? I can't find any
info on the proper use of these connectors.
Thanks
********************************************************
Mike-KK4MS
a_borg@yahoo.com
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|