Amps
[Top] [All Lists]

Re: [Amps] 4-1000A in LK2000

To: "Amps@contesting.com" <Amps@contesting.com>, Kevin LaHaie <klahaie@centricata.com>
Subject: Re: [Amps] 4-1000A in LK2000
From: aborg <a_borg@yahoo.com>
Date: Fri, 3 Jul 2009 11:20:07 -0700 (PDT)
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I have a homebrew 4-1000A amp I built a couple of years as well. I standing by 
for the source of 3-1000Z tubes as well.

Thanks
Mike-KK4MS
a_borg@yahoo.com


--- On Fri, 7/3/09, Kevin LaHaie <klahaie@centricata.com> wrote:

> From: Kevin LaHaie <klahaie@centricata.com>
> Subject: [Amps] 4-1000A in LK2000
> To: "Amps@contesting.com" <Amps@contesting.com>
> Date: Friday, July 3, 2009, 1:56 PM
> I have a change to pickup up a good
> condition BTI LK2000 floor console 
> amplifier.  It has the heavy duty power supply (but is
> not labeled as an 
> HD), includes the DL-2000 dummy load so it is a complete
> example of this 
> cool amp, and was built in 1969.
> 
> This amp still has the original 3-1000z, and after all
> these years in 
> contest service, it can still put out about a KW, but
> obviously well 
> down from the factory specs. (I have the original documents
> that came 
> with the amp)
> 
> The documentation claims that the 4-1000a can be also be
> used, and I 
> have a handful of them.  Per the manual, the only mod
> required is to 
> shorten the plate cap a bit since the 4000 is a bit taller.
> I had a 
> spare HC8 cap, so I performed the mod and tried several
> tubes, but my 
> issue is high input SWR. The tuned input range is not
> adequate to 
> provide a low input SWR, so the exciter only puts out about
> 50 watts, 
> resulting in output power of only 3-400 watts depending on
> the band.  
> Not acceptable.
> 
> I haven't put it behind the trusty TS-830S with the Pi
> network in the 
> finals, which would drive it fine, but that is not what I
> hope to use 
> with this amp.
> 
> Is the input impedance that different from the 3-1000?
> 
> I was hoping to get decent performance with the stash of
> 4-1000a's I have.
> 
> Does anybody know of a source for 3-1000z's?  If so,
> let me know.  It 
> will influence my decision to acquire this amp.
> 
> 73 Kevin K7ZS
> 
> 
> 
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 


      
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>