Hi Jose,
I repaired quite a few of these amps, so I can tell you some of the highlights
of this amplifier that I would like to share with you:
1 - HV Caps were made for 10 years of usage max. This amp is now like 25+ years
old, these caps make a sissing noise just before they explode.
2 - The filament CT-return is not cut off during RX (add relais!), meaning the
tank circuit can build up very high voltages during RX. When voltage raises
high enough, a flash on the band-switch will occure and simply destroy (contact
actually melt into water drop shape) the contact points, these are pretty small
in size you see.
3 - The 22 ohm resistors in the anode anti-parasite L+R (on top of the anode
cap) are broken.
4 - The 33 ohm resistors in the back compartment (Grid resistors) are broken
(often one of two after a flash over) or out of range.
5 - One of the many doorknob caps, specially on the anode side (1000pf/3kV) is
broken. Also in the tank ciruit a quite a few of this type of caps. I have
replaced many due to the fact that they were out of range due to aging or high
tempratures or simply broken.
Look at the website of < PA0FRI >. (search via Google) click on the < QRO >
option, then at the bottom of the page you'll find < FL2100 > section. Lots of
text / photo's from my amps.
I hope this helps finding the fault in your amplifier.
Vy 73, de Kees Member of an all HAM familyAmateurRadio : PA7TWO - M5TWO
Locator: JO22jp
> Date: Thu, 24 Jan 2008 22:51:46 -0600> From: joseart@navegante.com.sv> To:
> amps@contesting.com> Subject: [Amps] Arcing noise in Yaesu amp> > Hi, I have
> a Yaesu FL-2100B as my standby linear and I just installed it > because my
> 30L-1 decided to stay in the transmit mode permanently > (another repair
> project for later). The amp uses two 572B tubes.> > The Yaesu loads very well
> but sometimes there is a noise like arcing, > and I haven't been able to
> pinpoint the origin. Could it be possible to > be coming from inside one of
> the tubes? I haven's seen any traces of > arcing when I have opened the amp
> for cleaning.> > If anyone out there has had this same problem, any help will
> be > appreciated.> > 73,> > Jose Molina, YS1MS>
> _______________________________________________> Amps mailing list>
> Amps@contesting.com> http://lists.contesting.com/mailman/listinfo/amps
_________________________________________________________________
Connect and share in new ways with Windows Live.
http://www.windowslive.com/share.html?ocid=TXT_TAGHM_Wave2_sharelife_012008
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|