Could you send a link for the K4POZ caps? I could not find it.....
I did find http://k4poz.com/ with stuff for sale, but no caps.
I am looking at changing to "Snap In" on my Ten Tec Titan and using the wd7s
board to mount them.
http://home.earthlink.net/~wd7s/hv-2.htm
I am also curious where John found the "Snap In" caps so cheap.....
73,
Joe kk0sd
K4POZ sells 390uF/450V 105deg on QTH.COM. I've bought many for amps
and never had an issue. His are 2.50 each.
- Paul
At 07:47 PM 1/16/2014, you wrote:
>I am repairing an Alpha 87A and need 7 HV filter caps (350uF @ 450v)
>screw terminal. The Alpha people spec for a Cornell Dubilier part
>(CGS series) that costs $40-50 each at various sources. On the
>other hand I can buy a different series (381LX) from Cornell
>Dubilier that has 330uF @ 450v with very similar specs including
>tolerance, temperature, ripple, DC leakage and ESR . These would
>cost me $2 each. The expensive ones are 5" long screw and the
>cheapo's are 1 and 3/4" snap-in. I think I can easily fabricate
>small screw down double-sided copper thru-hole PCB adapter boards
>for the snap in's ... Is there another factor between these two
>electrolytic series that is not obvious in the Cornell Dubilier spec
>sheets that should push me to the $300 set versus the $14 set???
>
>john
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|