The getter on the GS-35B (and GI7-B, etc.) is on the cathode.
IIRC, the filament should be run for several days with no other voltages
applied. One site says to bring up the filament voltage gradually over a
time. Google is your friend, there's a ton on info about this out there.
73, Mike
www.w0btu.com
On Wed, Feb 25, 2015 at 3:25 PM, Ian White <gm3sek@ifwtech.co.uk> wrote:
>
> I'm not sure where the getter(s) are on a GS35B, but most likely close
> to the cathode which is the hottest part of the tube. I don't believe
> there is a getter on the anode because that surface doesn't get very
> hot, but if you do arrange for some extra anode dissipation, it will
> help to raise the temperature of the whole tube to some extent.
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|