Howdy folks, I have a vintage - as in untouched by golden screw drivers,
Dentron 160 - 10 L/M amp. It has been a good amp but I retired it a while
back when I went SS. I wanted to sell it, so I fired it up to get the
current output. With no carrier everything is just fine. HV right where
it should be. Zero deflection on the meter when switched to amps. I
mistakenly hit it with full drive and it popped the fuse. So, what I would
like to know is what I should check and it what order. These are simple
amps and I'm thinking it can't be that hard :)
If I have to replace the caps - I see that they are ones I have not seen
before with screws holding them to the PC board - what would a good
replacement be?
Thanks for allowing me to tap into your knowledge base !!!
Bear in mind this is factory original - even the original 572B tubes.
73
Greg
VE7GPG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|