Amps
[Top] [All Lists]

Re: [Amps] Direct-grounding SB-220 grids

To: Vic K2VCO <vic@rakefet.com>
Subject: Re: [Amps] Direct-grounding SB-220 grids
From: R L Measures <r@somis.org>
Date: Wed, 7 Jun 2006 02:59:48 -0700
List-post: <mailto:amps@contesting.com>
On Jun 6, 2006, at 1:07 PM, Vic K2VCO wrote:

> Pete Smith wrote:
>> I'm thinking about following several people's advice and
>> direct-grounding the grids on my SB-220.  I'm told that this can
>> result in a bit more gain and enhanced stability.  Merits of the
>> procedure aside, if I do so, should I use copper strap of some sort,
>> or will large diameter copper wire be sufficient?  Should I ground
>> each grid pin directly to the adjacent chassis ground lug, or somehow
>> connect them to each other?  It appears that each ground connection
>> will only be about an inch long.
>
> Copper strap would have lower inductance and is what I've used in my
> homebrew amplifiers.  If you're going to bother changing it, might as
> well do it the best possible way.  I don't see what the benefit  
> would be
> from connecting them together; I'd just connect each pin to the  
> chassis
> with the shortest possible strap.

The shortest possible Cu strap has c. 15nH of L.  At the 3-500Z's  
grid resonace (c. 88MHz) this represents roughly pos. 9-ohms of X.   
The original 200pF cap used to ground the grid has c. neg. 8-ohms of  
X.  Will the resonant frequency by increased by the use the cap or  
the strap?

> -- 
> 73,
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>

R L MEASURES, AG6K. 805-386-3734
r@somis.org



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>