N4ZR wrote...
>you and others might want to look into the small HiG d'Italia
>RF-switching relays that Allen Bond sells at mgs4u.com on the President's
>Page. They are rated 75 watts RF hot switching and I've used them for
>years on the input side of my SB-220. They are tiny too - the only rub is
>that they are 26.5 VDC. See
I bought a couple of these to try out. I was preparing one for mounting in the
amp and found the attached coax was a little too short so needs to be replaced.
I've attempted to disconnect the coax from the relay but all three lenghs of
coax (COM, NC, NO) are attached via the same shield connector that has three
solder connections to the relay. I've tried heating all three solder joints at
once with a butane torch, but the relay gets mighty hot and I think I may
damage it. Any suggestions?
Also, are these considered "reed" relays?
Thanks,
Steve KK7UV
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|