Amps
[Top] [All Lists]

Re: [Amps] Ducting Suggestion

To: "Roger \(K8RI\)" <k8ri@rogerhalstead.com>, <amps@contesting.com>
Subject: Re: [Amps] Ducting Suggestion
From: "Bob Good" <k4bg@planters.net>
Date: Wed, 21 Mar 2012 18:02:38 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Roger, et-al;  On my Titan II (4CX-1600) I use RV sewer hose to exhaust the 
air through my home brew panel in the bottom of the window behind the 
equipment where the feed lines pass.  I use screen wire at the outside 
opening to eliminate critters.  The outside end hangs down and moisture is 
not a problem.  No ant problem.  My amp sits on a home brew matching console 
in the knee hole of my corner desk.  The amp sits at a angle facing upward. 
I installed sound dampening foam inside the hollow beneath the amp with 
screening over the several air inlet holes to prevent dust bunnies from the 
carpet.  After over a year, no dust, quiet air noise, and no heat in the 
shack.  All I hear is the slight blower motor whine.  So far the hose is 
holding up fine under the UV.  I attached the hose to the top of the amp 
using nylon medical tape.  It holds well to the warm metal and the adhesive 
removes easily.  I'll gladly send a picture if you wish.  I enjoy reading 
the comments.  Regards,  Bob K4BG

--------------------------------------------------
From: "Roger (K8RI)" <k8ri@rogerhalstead.com>
Sent: Wednesday, March 21, 2012 13:27
To: <amps@contesting.com>
Subject: Re: [Amps] Ducting Suggestion

> On 3/20/2012 3:48 PM, Mr Mike wrote:
>> SLOOOOOOwwwllly workeing on a single gs-35b amp.
>>
>> I puchased a blower that is rated at 110 cfm @ .5" SP
>>
>> I am planning to make the HV p/s a seperate unit and am toying with the 
>> idea of remoting the blower as well, to reduce noise.
>> In this design there would be a 3" diam flexible tube running from P//S 
>> blower cabinet to remote amp chassis, about 6 feet long.
>>
>> I know flexible exhaust pipe would work, ants certainly tough enough, but 
>> has anyone any more aesthetically pleasing ideas?
> I don't know about more aesthetically pleasing, but to me the dryer hose
> is far too fragile. I'd pick the hose like we use with drops for the big
> all shop dust collectors.  Of course the fan used for suction on one of
> those would provide plenty of air if turned around to blow instead of
> suck.  OTOH you'd want the fan in another room. Some are the size of a
> snow blower and "Loud".  The hose is available from Ace, Lowe's, and
> Home Depot as well as many other sources. It is normally black and
> considerably heavier and much more robust than dryer hose. I think it
> typically comes in either 4 or 5" with adapters to smaller sizes.
>
> 73
>
> Roger (K8RI)
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>