In message <B0000300035@emerald.axnet.com>, Jon Ogden <jono@webspun.com>
writes
>>>You really should measure impedances in actual system with the layout
>>>and components used if you want to determine possible VHF voltages.
>>
>>I agree entirely - I just don't have an amp to do it on so I thought I'd
>>see what the individual component looked like. I'd be surprised if the
>>general effects I saw were to change massively when in situ
>
>It can definitely change. Especially impedances at higher frequencies,
>etc. That's the tough part about RF. I think you measured a capacitor.
>These are less affected by nearness to other components, shields, etc.
>than inductors, but I think you would see a modest change. Massive?
>Unlikely unless the circuit design is terrible. Modest? Quite possible.
>
For sure - 'general' and 'massively' were carefully chosen :-)
Steve
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|