Amps
[Top] [All Lists]

[AMPS] glitch resistors

To: <amps@contesting.com>
Subject: [AMPS] glitch resistors
From: Ian White, G3SEK" <g3sek@ifwtech.com (Ian White, G3SEK)
Date: Sat, 8 Sep 2001 13:52:27 +0100
OZ5IQ wrote:
>
>HI guys
>
>Why are the most of you talking of HV resistors   ????  Be  realistic and 
>think 
>that this is to avoid the current during arc.
>
>I Always put those current limiting devices at the LOW voltage potential.
>
>A few ex. could be : at the center to GND of the HV trafo, 
>                                   In the   - HV lead just between this and 
> the 
>GND.
>
>This is GD construction  design, and you get the exact same kind of protection 
>AND avoid  HV resistors  or HV  fuses.

That's  not true - and it can be dangerous! 

If the resistor is where you describe it, in a +3kV supply, a current
surge from the HV+ rail will push the center-tap towards -3kV with
respect to chassis. The voltage across the resistor is EXACTLY THE SAME
as if it was in the HV+ line. 

Also the center-tap is designed to be grounded (or very close) so the
insulation at that point may not stand 3kV.

There is a range of commercial amplifiers where they do this. The glitch
resistor and a 1-inch mains-type fuse are in the negative lead, just
mounted on the PC board with all the other low-voltage components. The
HV-minus connection is ordinary hookup wire, and it goes back to the
bottom of the capacitor stack through an un-insulated hole in the
chassis. This is all FB when the amp is operating OK, and it saves the
extra cost of mounting a resistor and fuse in the HV+ rail. But what
happens if there's a current surge, I dread to think - it could side-
flash to anywhere!

73 from Ian G3SEK          Editor, 'The VHF/UHF DX Book'
                          'In Practice' columnist for RadCom (RSGB)
                           http://www.ifwtech.com/g3sek

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>