Amps
[Top] [All Lists]

Re: [Amps] LK 500 ZA heat

To: amps@contesting.com
Subject: Re: [Amps] LK 500 ZA heat
From: Ian White GM3SEK <gm3sek@ifwtech.co.uk>
Reply-to: Ian White GM3SEK <gm3sek@ifwtech.co.uk>
Date: Tue, 14 Aug 2007 07:59:53 +0100
List-post: <mailto:amps@contesting.com>
Steve Thompson wrote:
>Gary McAdams wrote:
>
>> My question is: Would it be advantageous to add additional cooling via
>> something like added muffin fans on the sides pushing air into the amp?
>>
>> Or would that just be a waste of time?
>It might be useful - but not necessarily because of any effect on the
>amount of airflow. Air is like water, and follows the easiest route,
>This means it goes past and round objects, often leaving a layer of
>still air on their surface. Still air is a good heat insulator. Sucking
>air tends to produce this sort of flow. The air coming out of a fan is
>turbulent, and this can increase cooling effect by increasing the
>contact between moving air and the hot surface.

Steve is right. The turbulent air from the outlet of a fan makes a huge 
difference to the cooling efficiency.

If you follow a thin streamer of smoke through a typical flat-pack fan, 
the streamer holds together as the air flows smoothly into the fan - but 
on the other side it vanishes, completely mixed in by the turbulence. A 
thin thread of cotton held in the air-stream shows the same effect.

With an extractor-type fan, the tube sits in smoothly flowing air, which 
mostly takes the easy way through the wide open spaces, just as Steve 
says. A thin surface layer of hot air tends to stick to the glass 
surface of the tube, acting as an insulating blanket that keeps the heat 
in. Meanwhile, the valuable fan turbulence is being completely wasted 
into the room. In every sense, this arrangement sucks.

If the fan is upstream of the tube and blowing air onto it, the 
turbulence scrubs away that insulating blanket. The glass is in direct 
contact with cool air, and the surface temperature is much lower.

If users want a quiet amplifier above everything else, that fan 
turbulence is a hugely important asset - absolutely not to be wasted.

But the tube isn't the only thing that needs to be cooled. Most modern 
desktop amplifiers use 'full-flow ducted cooling', which draws cool air 
inward past the transformer, electrolytics and other parts of the power 
supply, before blasting the air directly at the tube(s). This tends to 
place the fan somewhere inside the middle of the cabinet, which helps to 
reduce noise. Finally, the hot air should be ducted directly out of the 
cabinet - not blasted at the tank circuit.

It isn't easy to get all of these things right. Every plan has problems 
as well, so we're looking for the best possible compromises.



-- 

73 from Ian GM3SEK
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>