Steve said:
>Expanding on those, any heatsink you buy will not
be flat enough without machining, ideally with a large diameter
'fly' cutter. You are also looking for a good surface finish with
machining ridges barely detectable with a fingernail. As well as
flat (50um or .001" over the module area) clean is important.<
Not sure that I would agree about a fly cutter. Better than nothing, but I
would prefer
a horizontal milling cutter. Alternatively, a face-and-end milling cutter.
A large slot drill
might give a good enough finish.
Another good way would be to use a shaping machine.
73
Peter G3RZP
----------
Zarlink Semiconductor Limited is a Company registered in England and Wales
under number 00705031 with its registered office at Cheney Manor, Swindon,
Wilts SN2 2QW, England.
This email is confidential and may contain information that is privileged and
exempt from disclosure by law. If you have received it in error, please contact
the sender immediately by return email and then delete it from your system; you
should not copy it or disclose its contents to anyone. Emails are not secure
and cannot be guaranteed to be error free as they can be intercepted, amended,
lost or destroyed, or contain viruses. Anyone who communicates with us by email
is taken to accept these risks.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|