On Mon, 19 Jan 2004, Marc Wullaert ON4MA wrote:
> Maby this could be better explained but if you look at the schematics
> there is a safety bar when you open the titan 425 . this bar make's a
> short to ground. but always first disconnect the mains and the hv wire
> first and wait 30 minutes. and if you still don trust ,take some
> isolated wire ,connect one side to ground/chassis and the other one to
> the anode off the tubes .
heh yep, I didn't discover that bar until i'd blown a couple fuses and
discovered it.
You can see it on the photos on tentec's site. It's a triangular piece of
metal attached to a screw in the chassis. Flip it over and it will rest
against the HV post that snakes through the middle cabinet wall.
73 Jason N1SU
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|