As a previous Henry owner 2K4 and 2006, I'd avoid ordering common parts
from them when high quality parts like capacitors, diodes, and switches
can be found at a fraction of the cost at the major parts suppliers.
However I never found substitutes for the illuminated, push button
switches. I had problems with schematics as well.
OTOH IIRC the circuit of the 2006 is pretty much straight forward,
however that was quite some time ago, so I'm relying on an old memory.
73, Roger (K8RI)
On 5/13/2018 12:47 AM, wt8r--- via Amps wrote:
Larry, I recently repaired a 2002 amp. The schematic I found is INCORRECT from
Henry. It is my belief that 8 filter capacitors (? uF @ 450 V) should be used
and not the pF variety described on the schematic. Replacement capacitors and
equalizing resistors were ordered from HENRY(Not CHEAP). Good luck. Dave, WT8R
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|