Jim, it is possible that the hum is present only in your local receiver and
not actually being transmitted.
As a test, you might have a local listen to the signal and give you a
report.
73,
Gerald K5GW
In a message dated 10/16/2013 11:59:55 P.M. Central Daylight Time,
audioguy@q.com writes:
After replacing the filter caps and equalizing resistors, I fired up
the 76A today on 40m and had a couple of nice contacts. The 120hz hum
problem *appeared* to be gone. The spectrum analyzer showed a nice sharp
clean carrier, with no "funnies" in the sidebands or for a few mHZ
either side.
And then I tuned up on 160m. 120hz hum like crazy on a carrier, hum
distortion on SSB. Unusable.
Tuned up on 75m, clean as a whistle.
So - it hums like crazy on 160m, but not on the other bands.
Plate choke and/or bypass caps? It loads up fine on 160, just hums like
crazy.
Ideas? (other than exorcism)
Thanks,
Jim N7CXI
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|