Wow - touched a nerve on that one, didn't I? Any legally-operating ham
would just say "Nonsense, I always operate legally" or words to that
effect. I see nothing remotely like that in your drivel below.
My comments are interspersed. Jom's quotes start with ##
>## I'm on AMPS.. and the yahoo ham_amps... and that's it. You say
>you have built 5 x amps.. why not post the pix on ham_amps... like
>I did? I posted 150+ pix on there. Where's yours ?
Since you asked so nicely, I took one just for you:
http://www.flickr.com/photos/w6wrt/4466281557/
That's a power meter right next to it. You are probably not familiar
with this model since it only goes to 3kW, which I have never come
close to by the way. What do you use? Something the VOA would be proud
of, no doubt?
>
>
>## Remember that argument
>about how a simple tuned input works, and how, without one, the return
>current is via the coax shield going back to the xcvr, then up through the
>load cap of xcvr.. and back down center conductor, back to cathode. You
>still don't believe it, even after Tony King posted the Orr classic diagram
>on the other reflector. I bet you $1000.00 CASH, that's how it works.IOW,
>put up or shut up.
The Orr Classic diagram proved nothing because the supposed "return
path" you were so hot about actually ended in mid-air and wasn't
connected to anything. Remember? Where's my money?
>##You vanish into thin air for a while... and come over to AMPS.
I was a charter member of ham_amps, but the illegal-amp crap from you
CB rejects finally got to be too much. I came to this reflector to be
with some hams who have respect for the rules. But then you came.
Arrrrrrgh. I do notice you have toned down your illegal-amp rhetoric
a lot on this reflector. How come? A little chat with the moderator
perhaps? Or just a guilty conscience?
>Now ur spewing BS, about how RF bores right through solid 1/8" AL.
Proven by two independent experiments with copper sheet, not aluminum
and it never was about anything 1/8" thick. Pay attention.
>
>
>Very few in the uk-zl-vk-zs land obey their 400w rule. Nobody in Italy
>obeys their 300w rule. Would you ? How come 20 kw ERP is ok...
>with stacked yagi's on big tower's ?
Earlier in your post you said you never justify your bad behavior by
pointing to other's bad behavior. What do you call the above?
>## Just for the record, I had my ham license suspended for 2 x weeks
>back in 1977.. over RFI/TVI. I had my license suspended for 6 x months
>about 5 yrs ago. If I'm not at the top of their bad boy list, I'm 2nd from the
>top.
>The 2nd suspension was over ant's.
<snip>
>## City hall wants my license revoked permanently.
>I made page 1 of the local paper about 6 x now.
More evidence of a scofflaw mentality.
>
>## There is almost 600
>of us on the yahoo amp reflector.... how come you left ?
Lids like you, as mentioned previously.
>##Where's my $1000.00 ?? Would
>you like to bet another $1000.00 cash that RF won't pass through 1/8" thick
>AL plate.
I never agreed to any bet, but if you insist, I'd say you owe me $2k.
CBA is fine, thanks.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|