Hi Jim,
I'm younger than the average ham, and I took up Morse code recently. I
can tell you from personal experience that the method that you describe
doesn't work very well. I tried using the "CwGet" program on some DX
pileups because the operators were going too fast for me to copy by ear,
and the results were very poor. CwGet seems to have a good reputation
within its category, so I doubt that the problem was my choice of software.
The software deals with QRM brilliantly; a few Hertz of separation is all
it needs to ignore an interfering signal. However, when looking at the
amplitude vs. time graph shown by the program (similar to an oscilloscope
trace), it can clearly be seen that a lot of very-short-duration QSB
frequently stymies the computer, which the "computer between the ears"
handles effortlessly. For instance, a "dit" will have its amplitude
reduced by 50%, which will be below the threshold that the software will
copy, changing a "D" to an "N". (The threshold is adjustable, and I had
tweaked it very carefully.) What was RST 579 to my ear was more like 279
for the software; several repetitions were required to understand what was
being said. To be fair, I think I was on 40m, but the QRN was very mild
at the time.
It didn't take me very long to realize that computers are much better at
comparing the amplitude of two tones to find which is louder (RTTY) than
determining if a single tone is present or not (Morse code).
There is another annoyance: the software introduces a time delay. If I
remember correctly, it is between a half second to a second. That is
acceptable for a ragchew of course, but not for contesting or DXing.
I tried using CwGet a couple times, and that was enough. I stopped using
it and concentrated all my efforts on learning the code the old-fashioned
way, and have been much happier with that approach. Of course with more
computational horsepower available in the future, computers will get
better at copying Morse code. However in my opinion Morse code appeals
because it is fun to copy it by ear. (Well, fun once it has been fully
learned at least.) If I wanted just a digital mode then I would pick one
that that computers copy better, such as PSK31.
By the way, I have run into several other relatively young hams who are
also learning Morse code. There aren't nearly as many learners as there
were in past years I'm sure. In my opinion, fifty years from now there
won't be nearly as many hams as there are today, and a smaller fraction of
those will be using Morse code, but Morse code will still be alive and
well. I think that the main thing that will keep it alive will be
contesting.
73,
- Rob W7GH
On Fri, 02 Feb 2007 06:39:09 -0800, <Jimk8mr@aol.com> wrote:
> Be wary of getting what you ask for.
>
> If there are to be any new CW operators in the future - unfortunately
> not a
> certainty - it will probably be from people combining a code reader and a
> speaker. Watching and listening to repetitive patterns - CQs, 5NN OH,
> your own
> callsign - will be the start of learning code as one recognizes by ear
> what
> one sees on the screen.
>
> I don't think many people will want to go through the work of learning
> the
> code before they operate, but some just might learn the code while they
> operate.
>
> 73 - Jim K8MR
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|